British Gypsum Gyproc Easi-Filler 60

Gyproc Easi-Fill is a lightweight plasterboard joint filler and finish, formulated for easy mixing and sanding, and consistent setting time. It may also be used for many other internal adhesive and filling applications. Gyproc Easi-Fill combined setting and air drying gypsum based material for bulk filling and finishing of joints.

Key Features 

• High coverage rate
• Easy to mix
• Minimal drying shrinkage
• Allows application in only two coats
• 60 minutes working time
• Final coat can be applied after 120 minutes
• Complies with EN 13963, type 3B

Application 
Gyproc Easi-Fill is used for all stages of plasterboard jointing- for pre-filling gaps and holes and for fixing of beads. It has very low shrinkage, allowing a finished joint to be achieved in only two applications. It can be used by hand or in quick-release type finishing boxes from the speed tape range of mechanical jointing tools (note that it should not be used over an earlier coat of and air-drying product such as Gyproc Joint Cement). Gyproc Easi-Fill should not be used for jointing of Glasroc MultiBoard or FireCase (S).

Installation
The powder should be added gradually to clean water in a clean mixing vessel, stirring continuously until a smooth creamy consistency is achieved. Apply Gyproc Easi-Fill to the joint to embed the tape and immediately overcoat to fully fill the tapered board edges and just feather out onto the board surface. Allow to set for 140 minutes-then apply the finishing coat, feathered out beyond the first. After the coat has dried sand lightly to remove trowel marks. Apply Gyproc Drywall Primer to the whole surface to prepare the surface for painting, apply the decoration with the minimum delay.